TH Telemetry 2400Mhz 100mW

• TH-Telemetry Module is an enhanced version and replacement for the widely available 3DR Telemetry Module.
• TH Telemetry is 2400Mhz 100mW Radio Telemetry V2 Kit is based on the 3DR Telemetry kit and is 100% pin compatible with 3DR/SiK radio.
• The Telemetry Module is compatible with Ardupilot & Pixhawk-based systems and allows you to easily add a two-way telemetry connection between your drone and ground station.
• This is the new and improved V2 of the Mavlink Telemetry. Please note that to connect to Pixhawk, please purchase a 4-pos to 6-pos cable.

Features

• Very small size & Lightweight (under 4 grams without antenna)
• Transparent serial link
• MAVLink protocol framing and status reporting
• Both Mavlink v1 & v2 are supported.
• Processes up to 100 mavlink pkts/second
• Spread Spectrum 2400Mhz
• Adaptive Data rate upto 200 Kbps
• Latency is 50% less than ExpressLRS (14 ms)
• Full 300 bytes support.
• Configurable duty cycle
• 100 mW maximum output power (adjustable)
• Based on the SX1280 module
• RP-SMA connector
• 2-way half-duplex communication through adaptive LoRa Spread Spectrum
• UART interface (115200 baud, 57600 baud, 921600 baud)
• Transparent serial linkMAVLink protocol framing
• LoRaSpread Spectrum (FHSS)
• Configurable duty cycle
• Inbuilt Error correction.
• Configurable through Mission Planner and Q-Ground Control
• The demonstrated range of several kilometers with a small Omni antenna
• Can be used with a bi-directional amplifier for even more range
• AT commands for radio configuration
• Over the Air (OTA) support via WiFi
• Network id supports up to 255 networks
• 3D Printed Enclosure

Package Includes: 

• 1 x Air Unit
• 1 x Ground Unit
• 2 x Antenna
• 1 x Ardupilot Connector Cable
• 1 x Pixhawk Connector Cable